DLQ Outlander 2.5 Quadcopter TPU parts

youmagine

TPU prints for my custom DLQ Outlander 2.5 quadcopter. It's a 2.5 inch quadcopter based on the same geometry as the impulse alien, but smaller in size. Here are the parts used in my build: Frame: I use an armattanproductions frame that takes m2 hardware with 22mm standoffs (see link below). Flight Controller: My flight controller is a banggood 20x20mm betaflight f4 noxe MPU6000. It's an AIO-OSD model with a built-in LC filter for RC drone use. ESC: I choose the HAKRC 20A BLheli_S-BB2 2-4S 4 in 1 brushless ESC, which supports DShot600 for RC drone FPV racing. Motors: My motors are Eachine lizard95 FPV racer spare parts 1104 6000kv 1.3s brushless motors, used for RC drone FPV racing. FPV Camera: I use the Foxeer arrow micro pro 13 CCD 1.8mm M8 lens 43-600TVL PAL/NTSC FPV camera with an OSD black/blue/red model. Receiver: My receiver is a Frsky XM micro D16 SBUS full-range mini receiver, which supports up to 16 channels for RC FPV racing drones. VTX: I use the Runcam swift vtx, available on amazon. Props: My props are EMAX geprc 4 inch props, used for RC drone FPV racing.