DL-44 (Han Solo) Blaster scope crosshair

thingiverse

This is a simple crosshair that can be printed and inserted into the scope of the excellent DL-44 Han Solo Blaster by PortedtoReality. I wanted to add a little extra detail to the scope and I felt like a crosshair would be a nice addition, this simply slides into the thinner scope section and adds a crosshair to the scope when you look through it. It has a outside diameter of 18mm but you may need to scale it slightly in order to achieve a nice interference fit, for example I printed mine at 101%. Take care when sliding it in to the scope so that the crosshairs remain parallel. I inserted the crosshair until it lined up with the 2 small holes on top of the scope for the Windage assembly, once I was happy with the orientation I added a couple of drops of super glue through one of the holes to secure it in place. You may need to take a few mm off the pegs of the Windage unit if the crosshairs cause clearance issues. I printed at 100% infill with a brim to keep it in place, and it may need minor clear-up at the end for a snug fit. Like I said, experiment with the scale to get the diameter right, it only takes 10 minutes or so to print.