DJI Tablet Mount

thingiverse

This is a tablet mount I created for my Galaxy Tab S3 and the controller for the DJI Mavic Pro. I designed it in Fusion 360 and then 3D printed it with precision. If you download, print, and enjoy the design yourself, please consider leaving a tip as a gesture of appreciation. Getting everything just right took a significant amount of time to perfect. Please note that using the design for profit is not allowed. Here are some specific details about the mount: Mounts seamlessly onto any GoPro Mount Four 10mm screws are required, with two being optional. Additionally, you will need four nuts. A hex key is necessary for adjusting the mount, but a square key can also be used on the bottom plate and the optional controller mount portion. One 25mm screw secures the bottom plate firmly in place The springs needed measure: Two springs that are 22mm x 9.5mm with an inside diameter of 7.5mm (or .85 inches x .37 inches). I sourced these from Home Depot as part of a pack of assorted springs for $5. I designed and printed the mount using PLA, which provides sufficient strength. The print settings used were four perimeter walls thick, although my initial test print with two walls was surprisingly strong despite only having 20% infill. If you choose to use ABS instead, consider printing a partial part to check how the screws and nuts fit. You may need to increase the scale by .5 to 1%.