DJI Spark extended landing gear

thingiverse

My enhanced landing gear design for the DJI Spark is a two-part creation that simplifies printing. To assemble, you'll need 3 M2 x 6mm bolts per leg. Make sure motor mount holes are completely cleared out and use the bolt to secure the lower leg in place. I used a 1.5mm drill bit to clear self-tapping holes. For extra stability, I applied CA glue between the two parts; they should remain firmly attached. Alternatively, you could opt for nuts if added security is desired. While ABS is not my preferred material, it proved ideal for this extended landing gear. After trying PETG, which ultimately broke during installation, I found ABS to be the best choice. Before attaching, thoroughly clean the motor mount area with sandpaper and then push and twist until securely seated. For a flush fit, start by pushing the outside onto the arm as far as possible before seating it towards the body.