DJI O3 Unit + Antenna Mount (TPU)

thingiverse

This is two parts: 1: mount with 4 screw holes for the DJI O3 main unit 2: mount for included DJI video antenna I modeled this on a iFlight Nazgul5 V3, but the measurements and bolts are as follows: Main DJI O3 mount: 30x30mm screw spacing, intended to be used with M3 screws Antenna Mount: 25mm spacing between two posts, posts measured roughly 5mm diameter The DJI O3 mount allows the end user to have full access to the Micro SD slot, USB-C port, along with the indicator light and Link button. The antenna mounts at a 30 degree angle outboard of the rear of the drone. You will need to temporarily disconnect the antenna plugs before installation. The pieces are a snug fit if you print in TPU, I wouldn't advise printing in solid filament. There is an added nub on one side to allow for removal later, will not dislodge during flight.