DJI O3 Canopy for Racer-X Twig Mutant (and others)

thingiverse

New version files uploaded (if you downloaded any files before 12/19, then re-download the newer versions, these allow for use with ND filters, among other improvements) These are my body shells that accepts the DJI O3 Air Unit and Camera. These body shells will ONLY work in conjunction with a normal quadcopter carbon frame (this has no structural strength of it's own). The Aero version parts will only match shape with a Twig Mutant 4" frame. NOTE: The models marked 4in are for 4" or larger quads (the rear intake ducts need clearance), generally, if the prop tips are too close together to clear an antenna in the rear, then the ducts won't fit (have uploaded a smaller ducted version for 3", and I am making a ductless version for other size models with tighter prop clearances). 3" versions are now uploaded, both "mod" and "complete", mod mates to a base (I like to run PC translucent so that it lights up), complete is a single piece version. It's camera angle is fixed at 35deg of up tilt, the camera must be installed before the Air Unit and the cable from the AIO flight controller must be long enough to reach up out of the top of the canopy for the Air Unit cartridge to be plugged in before being slid into place. The main parts to the body of the Aero version for the Twig Mutant frame: Mod Canopy Body - Supports required Aero Mod Base Body - Supports required Aero Mod Lower Body - No support, print directly Air Unit Tray - No support, print directly sideways Antenna Lock - No support, print directly upside down Alternate to that, there is a different base that can be combined with the Mod Canopy Body Mod Basic Base Body - Supports required And, there are now a single piece canopy versions Complete Canopy 4in plus - Supports required Complete Canopy 3in - Supports required The different damping screw plates are used in conjunction with O-rings of various sizes (1.5mm cross section), I use them with silicone rings. There are 5 types, 3 of which use O-rings, 3.6mm (no groove), 3.4mm (1 groove), 3.2mm (2 grooves), 3.0mm (3 grooves) and the 4th type is a lock that is used without an O-ring (but can be printed of TPU for damping use). The damping screw plates are the only items that need to be printed twice per build (the rest are 1 to 1) The forward pocket is sized for a Crossfire Nano RX, and the aero version has a place to mount the crossfire micro antenna embedded in it (2 channels to route the antenna, and holes to route the antenna into that forward wing lower section).