DJI Mini 2 Tablet/Phone Holder

thingiverse

Note: rotate the toppiece 90 degrees to lay flat on its back to print it without needed supports. This is a clamp on tablet/phone holder for the DJI Mini 2 remote. Might fit the Mini 1 remote too. It's rough, very rough but it works well enough for my needs so I thought I'd share it. If anyone wants to remix it and make it prettier please by all means. There are multiple slider pieces, you'll need a upper and lower for the set. Print the ones that will hold your device. I use the long ones to support an Ipad Air gen 1. The smallest ones should hold most phones unless it's really tiny. You can mix and match the sliders to get a good working size for whatever you're using. The sliders will need to be sanded to get a good fit in the holes for them on the top piece. To securely hold a device I put a bead of hot glue in the V shape, it makes for a no sideways slip surface. I'm using rubber bands to add tension to hold the device in place. You'll need 2 of the screws. The brace piece needs to be glued to the bottom of the bottom piece. It's used to keep the gap open for cords to run. Left it as a extra unit in case people don't want t use it. Again it's rough but functional.