DJI mic receiver/transmitter hotshoe quickmount

prusaprinters

I use the dji microphone in split channel mode for capturing ambient noise and speaker on seperate channels. I hated having to use the hotshoe mount AND having to plug in the cable for every single time. This print combines everything so plugging in the receiver and the transmitter is a single action. The camera and microphone setup is now a single unit with only the speaker transmitter being on the, well, speaker.This case holds the 3.5mm cables at the correct height and orientation that inserting the receiver/transmitter automatically plugs it in and retains the device so it doesn't fall out.It uses rode mic cables between the shotgun mic and the transmitter as well as the receiver to the camera. I haven't tested with other cables. (These cables are right angle with a 9-9.5mm outer diameter and a rubbery coating so you can jam them into the holes.