DJI Mavic Tablet Mount & Battery Holder (Optional Sunshade)

thingiverse

ABOUT THE DESIGN: I scoured the web for various tablet holder designs but was unhappy with every aspect of them. So, I combined the best features from different models to create a unique design specifically tailored for DJI Mavic. This creation is based on an Asus Nexus 7, which is an 8.8-inch tablet, and while it's adjustable, you may need to modify it further to suit your own needs. The design should work with most tablets around the same size. USAGE NOTES: To insert or remove the Mount from the controller, simply pop out the support arms so that they drop below the controller (It'll become clear once you assemble everything). You can use the tablet holder without the sunshade if needed. Make sure to plug in the USB cable to the tablet and power on the controller before plugging in the battery cable into the side of the controller. If you don't follow this order, the controller won't recognize the tablet with the battery plugged in. INSPIRATION FOR DESIGN: http://www.thingiverse.com/thing:1869930 http://www.thingiverse.com/thing:2045267 http://www.thingiverse.com/thing:1852670 http://www.thingiverse.com/thing:779785 http://www.thingiverse.com/thing:338478 CONSTRUCTION INFO: 4x M3 Nuts (Clamp & Hinge) 2x M3 Lockwasher (Clamp Hinge, Recommended) 2x M3 Washer (Clamp Hinge, Optional) 1x M3 20mm Screw (Clamp Hinge) 3x M3 40mm Screws (Clamp) 4x pieces of 1.75mm filament for the sunshade hinges (about 25mm long or use M2 25mm screws and nuts). Melt the ends of the filament after installation to keep them in place, or simply cut them off if using pre-cut pieces. Battery: https://www.amazon.com/gp/product/B01M1JR65I/ref=oh_aui_detailpage_o07_s00?ie=UTF8&psc=1 (Note: This battery is no longer available on Amazon. A similar-sized alternative can be found here: https://www.amazon.com/dp/B01M09NAG3/ref=psdc_7073960011_t2_B01M1JR65I) Adapter for Micro USB Mavic Cable to USB-C: https://www.amazon.com/gp/product/B01C43FUIW/ref=oh_aui_detailpage_o03_s01?ie=UTF8&psc=1 (any adapter of similar size will work.) Print Settings: Printer: Da Vinci 1.0A Repetier .92, Bowden, e3d v6 Hotend. Rafts: Doesn't Matter Supports: Yes Resolution: .2 Infill: 40%