DJI Inspire 1 Battery Heater

thingiverse

READ THIS VERY CAREFULLY BEFORE PRINTING!!! For safety reasons, it is essential to use the following printer settings for PLA: Temperature: 210°C Layer Thickness: 0.1mm Use high-quality cyanoacrylate to bond the parts of STL-files 1 and 2. STL-File 1: Minimum Fill Density: 50% Maximum Speed: 35 mm/s STL-File 2: Minimum Fill Density: 50% Maximum Speed: 35 mm/s Support is highly recommended for square cavities. STL-File 3: Fill Density: 100% Maximum Speed: 35 mm/s These settings are crucial to ensure the high quality of the final part. Due to these settings, the printing process can take longer than 15 hours, so be patient and allow sufficient time. If you modify these settings, always do it with the intention of increasing stability in the parts! The thermal bags required for this project are not included and must be purchased separately.