DJI Air Unit - Compact Enclosure - Actively Cooled

prusaprinters

<p>This DJI FPV System air unit enclosure is actively cooled and specifically aimed at ground FPV enthusiast where there isn't going to be enough airflow to properly cool the Air Unit. The unit is cooled by a 40mm fan (5v in my case). The enclosure is a lot simpler to build than my other unit and is quite a bit smaller.</p><p><strong>Update - April 2022</strong></p><p>I've added an alternate main body with holes for both the USB and SD card slot to make updates and storage more accessible.</p><p>See <a href="https://www.printables.com/model/62270-dji-air-unit-enclosure-actively-cooled">here</a> for camera mounting bits.</p><p>You'll need:</p><p>1 x 40mm fan (10mm thick)<br>2 x M3 12mm (to hold the fans)<br>2 x M3 nuts (to hold the fan screws)<br>1 x M2 10/15mm (for the center hold-down)<br>3 x M3 12mm (10mm also) (roof &amp; front-door)</p><p>Everything can be printed without supports. The orientation should be correct when you open the files. The Air Unit is a tight fit, though no sanding should be needed. Make sure you get your fan wire out the back (under the air unit) before putting the front door on.</p>