DIY Razer viper ultimate charging dock

thingiverse

The official charging dock is too expensive so i make one my self. parts list: usb A male x1 usb A female x1 (if you can't find the pcb bord in the picture) Φ6mmx5mm magnet x2 M3x6mm+6mm Hex Standoff Screw x2 1093D spring x1 soft copper wire 10cm Single core wire 4cm Hot glue gun Printing: All print with perimeters:2 infill:15% support on build plat only Assembly 1.Cut the spring in half and place it inside spring holder L and R. 2.solder the left and right screw to 2cm of Single core wire 3.put them inside spring holders and gule it in place with the maker faceing each other 4.solder the wire to positive and ground using the soft wire and glue the two magnet to the back of the plate 5.make sure the usb port are Align to glue it in place 6.snap in the lid first then snap in the back plate