DIY Raspberry Pi Zero W SMARTLEAF

thingiverse

Nope, not the first DIY nanoleafs and surely not the last one.. but this design is mine! It's a work in progress, with slight changes expected. The body and top piece snap together easily, inside there's room for 3x ~16cm of LED strips on the walls, a step down converter and a Raspberry Pi Zero W. The idea is to have one full module with the RPI, step down converter and LEDs, then connect other modules to it. It should be super easy to print and with only 5-15% Infill it illuminates nicely while being sturdy enough to mount on a wall. ## Hardware Raspberry Pi Zero W 3x 16cm LED/module 12V power supply DC step down converter 12V/5V ## Instructions For each module, you'll need 1x TOP and 1x BASE piece. Print with low infill for good illumination. Attach the Raspberry Pi with 2-4 screws to the base, wire up the LEDs, power source and voltage regulator. Full modules are designed to have the Raspberry Pi, voltage converter and LEDs inside while LED modules only have the LEDs as well as cables/connectors for daisy chaining. ## Electronics To be done soon ## Code To be done soon