DIY low cost E3D SuperVolcano (under $20)

thingiverse

This experimental SuperVolcano setup has not been fully tested yet. The design draws inspiration from the SuperVolcano and extruder setup found in thing 1977727. Components used include: 2x E3D volcano heating blocks: https://www.ebay.com/itm/3D-Printer-E3D-Volcano-Heater-Block-Heating-Block-for-Bowen-Extruder-V6-J-head 2x 12V 40W heater cartridges: https://www.ebay.com/itm/Reprap-12V-40W-Ceramic-Cartridge-Wire-Heater-3D-Printer-Prusa-Mendel/ 1 or 2 NTC 3950 thermistors with 100K resistance: https://www.ebay.com/itm/Reprap-NTC-3950-Thermistor-100K-with-1-Meter-wire-for-3D-Printer-new-fashion-TC 1x M6x38mm nozzle throat (with a 3mm inside diameter): https://www.ebay.com/itm/M6x38mm-Nozzle-Throat-Teflon-PTFE-for-3D-printer-1-75-3mm-filament-MK8-Extruder/ M6x8mm female hex screws made of brass: https://www.ebay.com/itm/5pcs-M6-Female-Hex-Screw-Brass-PCB-Standoffs-Hexagonal-Spacers 1x nozzle throat (3mm diameter, without Teflon): https://www.ebay.com/itm/1pcs-1-75mm-3mm-3D-Printer-Stainless-Steel-Feed-Throat-Tube-Nozzle-Extruder-Pipe/ 1x V6 extruder heat sink (short version, 3mm diameter): https://www.ebay.com/itm/V6-Extruder-Metal-Heat-Sink-For-1-75-3mm-J-Head-Fit-For-E3D-V6-3D-Printer-Tools/ 1x fan duct: https://www.ebay.com/itm/Radiator-fan-cover-Fan-Duct-for-E3D-v6-3D-Printer-Accessory-Blue-A3E2 1x 30x30x10mm fan (12v, 2-pin): https://www.ebay.com/itm/30mm-x-30mm-x-10mm-2Pin-DC-12V-Sleeve-Bearing-6000RPM-Cooling-Fan/ Nozzles designed for use with 3mm filament: https://s.click.aliexpress.com/e/0kUmSGFt1 Please confirm if you have replicated this setup.