DIY Headtracker Arduino NANO33 BLE (SENSE)

prusaprinters

<p>This is a housing design to be used with the open source head tracker from <a href="https://github.com/dlktdr/HeadTracker">https://github.com/dlktdr/HeadTracker</a>.</p> <p>My goal was to use it for both my Fatshark and DJI goggles by simple attachment with velcro.</p> <p>You can use either the NANO33 BLE or the NANO33 BLE SENSE board.</p> <p>The top part provides the holes and internal optical shielding required for the proximity sensor to work correctly.</p> <p>I used a 6x6mm micro push button for re-centering the tracker (works in parallel to the proximity sensor in case of SENSE board).</p> <p>While the front side of the Fat Shark goggles is flat, a simple piece of velcro will do. In contrast the DJI goggles have no flat surfaces. So I took some self-adhesive and stiff rubber plate as base for the velcro. Even if it is not really flat, this will work good enough.</p> <h3>Print Settings</h3> <p><strong>Printer:</strong></p> <p>Anycubic I3 Mega</p> <p class="detail-setting rafts"><strong>Rafts: </strong> <div><p>No</p></div> <p><strong>Supports:</strong></p> <p>No</p> <p class="detail-setting resolution"><strong>Resolution: </strong> <div><p>0.2mm</p></div> <p><strong>Infill:</strong></p> <p>100</p> <p><strong>Filament:</strong></p> any PETG, ASA, ABS... <p>any</p> <p><br/> <p class="detail-setting notes"><strong>Notes: </strong></p> </p><div><p>Solder the wires to the board's bottom side, there is room left for them.<br/> The screw holes are intended for M1.6x6 screws, as the board holes don't allow using M2 screws. <p>Optionally you can insert small pieces of clear filament into the LED holes, but leave the holes for the proximity sensor open.</p> </p></div></p></p> Category: R/C Vehicles