DIY Garage Door Case

thingiverse

Modeled in Fusion360 So a couple years ago I bought a dev board to open my garage door remotely from my phone, and had it sheltered in an empty wallbox, which worked, but made the terminals/buttons inaccessible to the outside. So I made this to solve that problem. Both sets of screw down terminals are accessible from the outside now, as well as the buttons and micro USB port. I used hot glue to secure the board to the bottom part of the case, and to reduce trouble with assembly, I used duct tape to hold the buttons in place while snapping the top and bottom halves together. NOTE: The buttons will fit be VERY snug at first, use a round file and flat file to sneak up on the correct fit.