DIY fish feeder (using towerproSG90 + arduinoUno)

thingiverse

Put together a fish tank auto feeder which works with a towerproSG servo. Build completed with a Towerpro90 servo, Arduino Uno, an RTC, a push button, 10k ohm resistor, a breadboard (82mm x 53mm x 9mm), pin wires, TM1637 display. Arduino code and schematic attached. Adjust code for feed timing, feed duration and quantity. Printing: Supports - not needed Infill - 20% Assembly: a. Secure plates together with diameter 3mm self tap screws or equivalent. b. Use a solder iron/ drill to create holes on the feeder drum depending on pellet sizes and feed quantity. Credits to: Matheus Frasson (https://grabcad.com/library/sg90-micro-servo-9g-tower-pro-1) - For Servo Step File Mateusz Zelek (https://grabcad.com/library/arduino-uno-r3-ch340-1) - For Arduino Uno STEP file