DIY - Cosplay 3d - Overwatch - Tracer Full Armor

pinshape

Hey folks. After 4 months designing it, It's time to take out Tracer's full armor (armband, chest, backpack, shoulders, mask and pulse bomb), broken down into 81 pieces/files ready to print, paint and wear. The design is based on an average woman's size, approximately 1.70 in height and 54 kg, so check your dimensions before printing it, and if you scale something remember to do it also on the closest pieces that match this one. The breast size is independent since the pieces offer mobility to adapt your size. The design is ready to put the necessary straps that join the cosplay set. The pulse bomb is independent, allowing electronics and lightning inside. You can attach or detach it easily to the backpack using rare earth magnets on the holes placed on both pieces. About printing settings: - PLA is enough but feel free to use other kinds of materials. I prefer PLA because I get a finer result thanks to good retractions and flow control. - Supports: A lot of pieces need them, but the good thing is that the supports always remain in the interior parts, so no detail is lost in the final result. - Infill: 20% - layer height: 0.1 is recommended. All pieces match each other; it will not be necessary to cut or sand the pieces as long as you have your printer properly calibrated. The pieces are designed to be printed with small format printers, so if you have a hot 11x11 bed, it is more than enough, but also there are full files to print in larger ones. To join the Armbands pieces, you will need some M3 screws; also on these files, you will find one separator that you can make thicker or wider to adapt your arm/wrist perimeter without needing to scale the other files. I hope you enjoy printing as much as I did designing it. Greetings, makers! BTW! I still haven't finished mine. It's on the way but unfortunately, I don't have all the time I would like; anyway, I left a picture of my progress.