DIY 3D Printed Push-Pull Magnetic Shifter

cults3d

This are some Push-Pull paddle shifters with The holes to attach this shifters to your wheel are for M4 screws and are 12.875mm apart. There are two versions of these paddles. One with the magnets contacting each other and another separated 0.8mm. If using the ones directly contacting, cyanoacrylate must be used to keep them in place. Parts for shifter: 2 x microswitches W37 - https://cutt.ly/ZUn32Nw 1 x Axles screws - https://cutt.ly/PUn30jY 2 x 10x5mm Magnets - https://cutt.ly/YLbOaAr 2 x M3 Screws 15 or 20mm long 2 x M3 Nuts 4 x M2.5 Screws 10 mm long FOR PERSONAL USE ONLY - NON COMMERCIAL - NOT FOR RESALE COPYRIGHT Canary Sim Wheel Designs - ALL RIGHTS RESERVED You cannot sell the digital model, a derivative or adaptation of the model, nor can you sell prints of the model.