DIY 15.6" Monitor

thingiverse

Hello!! This is my first attempt at building a case for these 15.6" displays. My ultimate goal is to create a completely modular setup and add up to two additional displays for a three-monitor configuration. The design's intent is simplicity, with a straightforward approach that minimizes complexity. Four corner pieces will hold the display panel while also supporting the back section. To complete this build, you'll need to print four Back Panel Quadrants, which fit into the second 1/8" slot on each corner piece behind the display panel. The Panel Mount is centered at the back of the panel and fits precisely where the 1/16" cutouts are located on the quadrants. The monitor arm goes inside the panel mount, following the monitor stand's alignment. This project is still a work in progress, and I'll provide updates as needed. Please let me know if you encounter any issues during assembly. Currently, there's no piece to hold the board controls, but I'm actively working on that component. I hope you guys enjoy this build and have fun printing it!