Diving Dry Suit Hanger

thingiverse

Needed: M8x60 Bolt; M8x30 Washer and standard M8 washers. Tested on Scubapro Exodry 4.0. The version shown in the photo costs significantly more than the .stl model. While printing my own copy, I made some modifications to the design. These changes reduced the bulk of the model, leaving plenty of room for further reduction, but a more substantial handle would be preferable. Printing with 12.5% infill will yield up to 240 grams of filament. However, there may also be room to decrease infill as low as 10%. My slice was set at 33.3% infill.