DisplayPort Dust Cover

prusaprinters

<p>A fast-printing plug to fit into an empty DisplayPort socket. Nothing special, just designed to print relatively easily.</p><p>You'll want to print this as oriented in the .stl, with the non-notched short edge on the build plate: this gives the print the best strength along the direction of insertion, to minimize the chances of breaking and losing any plastic inside the port.</p><p>The corresponding FreeCAD file is included. Please do not sell this model without contacting me first.</p><h3>Printing</h3><ul><li>Orientation: as in the file, the “wider” short edge down</li><li>Rafts: no</li><li>Supports: no (there is a small bridge that should be doable in nearly any filament)</li><li>Infill: anything</li><li>Perimeters: 2</li><li>Perimeter generator: Arachne, if available (the narrow widths benefit a bit)</li><li>Layer height: 0.15mm - 0.3mm (the part is designed be printed at 0.3mm layers and still fit, but thinner layers can produce a smaller bridge at the top of the print)</li><li>Material: PETG (PLA has a lower melting point and would be riskier if used in an active card)</li></ul>