Display stand for Raspberry 7" touchscreen

thingiverse

A custom display stand for the Raspberry Pi touchscreen is needed to replace the one that comes with this acrylic kit. The kit can be found at Kiwi Electronics, and the replacement stand should also be purchased from them. To print the stand, a Da Vinci Junior printer is required. Rafts are not necessary when printing this model, as it does not require support material. A resolution of 0.3 mm is recommended for optimal results, but 0.2 mm can also be used if preferred. Infill should be set to 10% for a balanced print quality. Note: It's worth noting that the user has only tested this model with a resolution of 0.3 mm and recommends using 0.2 mm for better results.