Display Case 20x4 for Compression Tester

thingiverse

Human: Display housing for a 4-line display type 2004 with an adjustable base.\nThe display housing is deliberately small and only slightly larger than the board of the display.\nThe viewing angle can be easily adjusted over a wide range by means of an articulated joint in the display foot.\nThe base plate is connected to the display housing with a countersunk screw M5 x 110mm and a M5 nut.\nAt the spigot-shaped ends of the base plate, two-centimeter silicone tube sections provide a secure support.\nThe display board itself is fixed without screws. The lateral caps on the housing also serve as a support for the board by clamping it in place.\nThe rear side features a M12x1.5mm thread for a PG cable gland.\nDue to the ten-millimeter inner diameter of the silicone tube sections, the display can be positioned scratch-free, for example, on a windshield. It serves here as a display for a compression tester.\nThe base plate can be printed without support.\nThe actual display housing requires support for printing. This should be printed upright on the page.\nFor necessary changes, I have attached the Fusion 360 construction file.