Disney World Magic Band Reader Stand

thingiverse

I just had to make sure I linked this to the Magic Band Reader I built for it. I printed the Disney World Magic Band Reader V2 - 4460759, but I needed a little stand to hold it up. I'm not adding any electronics, just a simple LED light string. You can see at the bottom of the stand there's a hole in the back for the power cord. There's also a small window in the front so your LED light strip (if used) has room for its remote sensor. You could then attach the remote sensor to that little window, and it will get the signal from the remote. This stand is made of two pieces. The main stand is hollow all the way up so you can run power cords if you want. The other piece is a cap that you glue inside the sphere once it's assembled. That keeps the stand stable and in place. There's a smaller hole in the cap to let the wiring pass through. Thanks!