direct bracket-mount for the DC power connector

cults3d

This bracket allows direct mounting of the solderable DC connector socket onto the project enclosure wall. I clipped the side pin, as it's not required, then carefully bent the middle pin backward to enable sliding the bracket over the connector socket from behind. Next, I drilled a 10x9 mm square hole through the project enclosure wall to expose the DC connector and created two 3mm holes for bracket mounting. M3 screws are used to secure the bracket by directly screwing into its mounting holes. Additionally, M2 screws from the top and, if necessary, bottom are applied to tighten the bracket around the DC connector socket.