DIN rail mount for raspberry pi

prusaprinters

<p>This is a simple 35mm DIN rail mount for the raspberry pi (tested with v2 and 3) that just snaps on with a torsional spring-mechanism and also works with the armor shield.</p><p>&nbsp;</p><p>It requires some support and a temperature resistant material is recommended (here: Colorfabb HT and Owens Corning PC-GF30… which might be a bit overkill; PETG should be fine too). Print it with low fan speeds and rather hot to have enough layer adhesion on the spring part. If you use the armor shield you can use the included screws, for a naked mount you'll also need 4x 2,5x6 screws and nuts.</p>