DIN rail mount for PowerPole connectors: upright

thingiverse

For mounting PowerPole DC connectors on DIN rails, facing upwards is a breeze. You can easily pick up a DIN rail mountable DC power supply on ebay, like Meanwell brand, and have it ready to go next to your setup if you prefer using PowerPoles over direct wiring. A short M3 bolt screwed into the bottom will give it extra grip on the rail. Printer Settings Printer: AIO Zeus Rafts: No Supports: No Resolution: 0.28mm Infill: 15% Notes: The key factor is how well your slicer and printer handle short bridges. Mine does a great job - the plastic doesn't sag too much. Printing in the designed orientation is likely best because you need tensile strength to hold the clamp onto the DIN rail; however, this requires bridging over areas where connectors will be installed. If those cutouts are too narrow, the part might split when trying to shove the connectors in. Design Details Check out http://www.thingiverse.com/thing:1788780 for more information - this uses the same DIN rail clamp design.