DIN rail mount for car fuse box

prusaprinters

This is an easy method for mounting a big car fuse box onto a DIN rail. I use that in my PV system. Goal was to have a fast printing thing, with low material usage and without complicated mounting mechanisms. print instructionsprint this 4 timesPLA is ok, but if you use it in hotter environments (car?) use more heat resistant material (PETg, ASA, ABS)20 % infill3 perimetersno supportsafter print, clear the holes with a drill bit from the builtin supports Installationyou need 4 M4 Nuts and 4 M4 ~15mm (countersunk) screws push nuts into the hex holes, if needed use a drop of super glue to keep them from falling out. (should be tight enough …)screw them under the fuse boxrotate the bottom pieces sidways, like in the pictureput fuse box onto the din railuse screwdriver to rotate the bottom pieces back done :-) additional notesI'm interested in your feedback to improve my stuff! So give me likes, post makes, comment and rate the print to show others and me how well it goes.If you post a make, let me know which filament you use.If you want to support me by donating a coffee go to https://ko-fi.com/antimaterie I would really happy about it. The money will be invested in all stuff regarding 3d printing to give more and better quality models.In general my Prints are not for commercial use, but if you are a print farm owner and want to sell some of my stuff, please contact me.Hope you enjoy my models.