Dillon XL650 Shellplate Holder / Organizer

thingiverse

This is a remix from AZJAKE who created the original design. Original design available here: https://www.thingiverse.com/thing:4128435 AZJAKE's profile can be found at: https://www.thingiverse.com/AzJake/about I designed this to hold every shellplate possible as of March 2020. For use with XL650/750 Shellplates, each one is clearly labeled. The screw holes are optimized for the 50lb plastic anchors from Home Depot or Lowe's (E-Z Ancor #25350). This design requires a long print; a full roll of plastic is necessary. I recommend using a 0.6 nozzle to complete the print within a day. A .4 nozzle will take approximately 1.5-2 days. I used Prusa Slicer with gyroid infill, which keeps the print time at around 22 hours when using a 0.6 nozzle. My slicer settings included a resolution of .3, but you can adjust this to achieve shorter print times or better detail. The design looked very nice at .3 resolution. Remember to add a brim in your slicer, as it may lift on the corners if not done so.