Dillon XL650 Ammo counter

thingiverse

This is a remake of ammo counter from CiscoFeatAkira (https://www.thingiverse.com/thing:4278319), posted with his permision. All of the parts were simplified to be as easily printable as posible. No supports needed. Angle of the ramp was slightly changed so it fits better on the ammo ramp of XL 650 and so it can be instaled and removed with the ammo bin in place and vice versa. Also added the way to adjust the position of the inductive sensor, if needed. Body of the counter is held in place using 5x3mm magnets (just what I had at hand) but can be easily changed to use different size, as soon as they are not thicker than 3mm. Magnets are press fitted and secured with drop of super glue, just to be sure. You will also need a metal axis pin to mount the arm to the body. I also recomend to enlarge the hole in he counter arm using a drill so completely free movement is ensured. I like to use a 2x40mm nail asi the pin. The magnet is attached to the counter arm simply by using drop ofsuper glue/hot glue. (don't worry that the magnet is on the oposite side of the counter arm than the inductive sensor is. It will work the same and it was done deliberately to get rid of the supports) Counter unit used is the one with two mounting holes on both sides of the display (shown in the picture) You can simply remove the metal mounting bracket on the back and reuse these two screws to mount it to the holder. Warning!: Counter reportedly does not fit properly the slide angle of D750XL!