dillon case feeder mount

thingiverse

This is a mount designed specifically for the open bullet feeder project created by ammomike83, intended for mounting on a Dillon case feeder. The one I acquired was purchased in early 2018, and it fits best at the location marked in the pictures but can be placed almost anywhere on the left side. To install the mount, start by inserting a section of threaded rod (I used 12mm x 1.75) to secure the two brackets together. Then, use a connector and two small screws to prevent them from rotating when positioned correctly. I opted for an 80% infill on the mount itself and a 100% infill on the connector for added stability.