Dillon 550 Calibre Conversion Kit Box

thingiverse

Box to hold a Dillon 550 Calibre conversion kit. Note: I haven't printed this exact version. I did print a v1 which works fine but had a few issues worth fixing: V1 was a couple of mm off square (but looked square) so it made the lid a 50/50 bet whether you'd get it right. v2 is square V1s pin holes were a bit tight (had to drill them out) - V2's are bigger. V1s funnel holder was a bit tight and deep so V2 is larger and not inset as far. V1s "knobs" to stop the shell plate spinning were smaller. V1 didn't have a central "peg" for the shell holder (it did, but it didn't print properly :) Added insets on pins so you can get a nail under them. The Photo shown is v1 with a .32 cal conv kit in it. If anyone does print this, let me know how it goes. My v1 works fine for me, so I don't need to print v2...