Digivice V-Pet Case Bottom Slide For 1997, 20th, & X -

thingiverse

I tried to print Zarch's case, but being as i only have PLA it wouldn't fit because his was designed to be printed with Flexible TPU. This was designed to be printed with a hard PLA from the get go. Fit's the Brick Style digimon V-Pets so the OG 1997 Releases, as well as the 20th releases, as well as the new Digimon X version releases. Changes include opening up the bottom and closing the right side but still leaving room for the keychain, as well as adding some parts for strength. Print at 100% scale for a good fit, you can however add .5 to the scale if you want a looser or tighter fit. To insert, press it in from the bottom and pull up on lower right hand corner and slide it up into the case. you may have to press the buttons down if they catch on the bottom of the case. Once fully seated it will lock in using the Key Slot on the front of the V-Pet. to remove just pull up on the lower right hand corner and push down from the top, it should slide right out.