Digital-Uhr klein (mit Scoreboard / Luftfeuchte und Temperatur)

thingiverse

I used PLA in black and transparent-clear. Required parts are as follows: Printing parts: (if you have a 300x300mm print bed) 1 piece: 7Segment Frame 1 piece: Rear part_Closed or Rear part_Open (either up or down, whichever you prefer!) 4 pieces each: Body A to G 2 pieces each: Point 1 piece: PCB holder Printing parts: (if you have a smaller print bed than 300x300mm) 1 piece each: 7Segment Frame 1-2 and 7Segment Frame 2-2 1 piece each: Rear part_Closed 1-2 and Rear part_Closed 2-2 or 1 piece each: Rear part_Open 1-2 and Rear part_Open 2-2 (either up or down, whichever you prefer!) 4 pieces each: Body A to G 2 pieces each: Point 1 piece: PCB holder Electronics: 1 piece: Arduino Nano 1 piece: Bluetooth module: HC-05 1 piece: Real-time clock: DS3231 30 pieces: RGB LEDs 5mm PL9823-F5 (WS2811) 1 piece: Temperature and humidity sensor: DHT11 1 piece: 2.1 x 5.5mm socket (DC - 005) Sources as of October 23, 2019 Arduino Nano https://tinyurl.com/y5wp38t3 Bluetooth module: HC-05 https://tinyurl.com/yy6k63do Real-time clock: DS3231 https://tinyurl.com/y24k687q RGB LEDs 5mm: PL9823-F5 (WS2811) https://tinyurl.com/y3a28qv5 Temperature and humidity sensor: DHT11 https://tinyurl.com/y5zrhu53 2.1 x 5.5mm socket (DC - 005) https://tinyurl.com/y22kldpm Software and circuit diagram are in the attached file. This clock is inspired by Leon van den Beukel, who kindly provided the sketch and an Android app. https://tinyurl.com/yxch46xe https://www.thingiverse.com/thing:2871608 ...ask questions if you have any!