Digi-Reaper With Base and Meshmixer Support

thingiverse

Modified the original with a 5mm tall base and added Meshmixer supports to a small area, allowing me to print without additional supports this time around. I chose not to upload the Solidworks files, as it's a remix, but these edits were straightforward enough that you may not need them. Print Settings Printer Brand: Robo 3D Printer Model: R1 ABS + PLA Model Rafts: Yes Supports: No Resolution: 0.1 Infill: 50% Notes: You can probably get away with less infill than I did if you prefer. To edit the model itself, simply load the without-support version of the original into your preferred program. Post-Printing The only post-printing task was removing the support material using pliers.