Diffuser for Moon Lamp Circuit Screw Cap for Progressive Detail Moon Lamp with Rechargeable Moon Station

thingiverse

**UPDATE:** Version 2 is a total remake that boasts an extended cover at the opening near the top, eliminating light leaks near the bottom and creating an extra bright spot! The wall of the tube has been thickened, but nothing has changed on the tip, so the effect remains the same as the original. I took the photo with my phone, but you can't really see the difference because...you probably know the problem if you're using those rechargeable generic moon lamp parts with 4 LEDs+battery+circuit board+touch control. Only 2 LEDs on one side will light up when the light is white/yellow, making projections of lighter/darker sides. I made this for "Customizable Moon Lamp Circuit Screw Cap for Progressive Detail Moon Lamp with Rechargeable Moon Station" by @edm00se (we can make the title even longer!). The above screw cap is based on "Progressive Detail Moon Lamp with Rechargeable Moon station" by @moononournation (our #1 moon lover!). The dimensions should be the same, but I don't have that square socket version of lights to test, so use at your own risk if you're printing for the original screw cap. It should fit snugly without glue if your printing dimensions are accurate. First, fit the open part to the circle opening for the recharging socket, then adjust to the opening on the screw part. Trim the bottom if your print has any elephant foot. Use brim then trim if there's any adhesion problem. Reduce X/Y by no more than 3% if you find it still too big to fit, then glue the bottom. Lower the object to reduce tube length if you really need to, just make sure the LEDs are covered by the cone, close to the tip but don't squeeze.