Diffuser for Flash (Yongnuo YN560-III)

thingiverse

This Diffuser is Made Specifically for the Yongnuo YN560-III Camera Flash, but It Should Also Work on the Mark 2 Because They Share the Same Shape. I Added Special Tabs to Keep the Diffuser from Sliding Completely onto the Flash, Which Allows for Better Room Diffusion. Print Settings: Printer: Hooklet3D Odin One Rafts: No Rafts Were Used Supports: No Supports Were Necessary Resolution: The Print Resolution Was Set to 0.2mm for Maximum Clarity Infill: The Infill Density Was Set to 30% for Optimal Structural Integrity How I Designed This Diffuser: I Scanned the Face of My Printer to Get Accurate Dimensions. Then, I Used Illustrator to Tracing Out the Shape of the Flash and Transfer It onto a New Design. Next, I Imported the Design into 123d Design Where I Could Extrude the Shape and Add the Special Tabs That Keep the Diffuser in Place. For a Full Walkthrough on How to Make Your Own Flash Bounce Diffuser Using 3D Printing, Check Out This Tutorial: Tutorial: Design a Flash Bounce Diffuser for 3D Printing.