Die Puzzle V2

prusaprinters

<p>remix of <a href="https://www.thingiverse.com/thing:199871">https://www.thingiverse.com/thing:199871</a> that snaps together like building blocks. no need for a box to roll it! also there is a trick hole that doesn't go anywhere! put it together wrong and end up with 2 fives:-0</p> <h3>Print instructions</h3><h3>Category: Puzzles Summary</h3> <p>remix of thing:199871 that snaps together like building blocks. no need for a box to roll it! also there is a trick hole that doesn't go anywhere! put is together wrong and end up with 2 fives:-0</p> <h3> Print Settings</h3> <p><strong>Printer:</strong></p> <p>xyz davincci 2.0a</p> <p><p class="detail-setting rafts"><strong>Rafts: </strong> <div><p>No</p>&lt;/div&gt;<strong>Supports:</strong></div></p> <p>No</p> <p><p class="detail-setting resolution"><strong>Resolution: </strong> <div><p>0.1</p>&lt;/div&gt;<strong>Infill:</strong></div></p> <p>solid</p> <h3> <br/> <p class="detail-setting notes"><strong>Notes: </strong> </p><div><p>use pla. pla has better layer bonding than some others like abs. solid fill for good feel. supports are pre-added in files. may need to adjust extrusion width/multiplier.</p></div> Post-Printing</h3> <p><strong>Tweeks...</strong></p> <h3> <div><p>"squish-out" can make bottom holes too small. use a 2.75 mm to 2.8 mm wide flat head screwdriver or a 2.5 mm hex wrench to bore these holes bigger.</p></div> <p class="detail-title"><strong>Clean up</strong></p> <div><p>use a good sharp hobby knife to remove supports, burrs, and squish-outed edges.</p></div> How I Designed This</h3> <p><strong>how I did it (in a nutshell)</strong></p> <p><div><p>downloaded the "assembled" version of original for reference. measured a die. it was about 16.2 mm. took off 0.2 mm for extrusion width; left with 16mm. made a blank piece (16x(16/3)x(16/3)) and closed file. copied 9 more of file. renamed. opened the 9 files (the other is for backup). for each file added holes and studs with a 3 degree taper. holes are 3 mm (min d) x 1 mm (deep). pegs are 2.8 mm (min d) x 1 mm (tall). arrangement of the pegs and holes are the same as reference except an added hole for laughs :-D</p> to assemble:<br/> front is the 6, bottom is the 4.<br/> bottom (front to back):<br/> files 1,2, and 3<br/> middle (left to right):<br/> files 4,5, and 6<br/> top (front to back):<br/> files 7,8, and 9</div></p></p></p>