Dick Blowgun

cults3d

Its a dick. Its a blowgun. Its a dick blowgun. This one might be a bit tricky for some. The dick itself is pretty long, so make sure your first layer and adhesion game is good. Both the blowgun and bullet should be printed as plated, and do not need supports. The bullet to blow gun fit is precise. Make sure you do not have any stringing or oozing issues, as if that happens in the barrel, it more than likely will not work. I use the setting "avoid perimeters" (Prusaslicer) to really make sure this does not happen. if you experience any roughness or protrusions around the barrel base or tip, clean up with a hobby knife. I run a heavily modified E3 that is well calibrated and the bullet to blowgun size is perfect as downloaded. If you do experience a fit that's a little too tight or too loose, I suggest you make small scale adjustments to the bullet, not the gun. The bullets print up extremely quickly. Its also fun to experiment with infill for the bullets. The weight does make a difference. The lighter they are, the higher velocity they can achieve but they tend to have reduced range. The heavier, the opposite. I have fun with them printed at 3 walls all around and 15% infill. Personally, I can knock over and dent soda cans on that setting. Enjoy.