Dicengard w/ Dice Storage

thingiverse

WIP Until all pieces have been printed and tested. Dicengard Remixed with a storage tray for your Dice. The top piece remains unchanged and can be found here: https://www.thingiverse.com/thing:2739056. Printing Original (no version) with no supports resulted in minimal issues, but points that may require support are under the windows and along the far back edge where the tray slides in. These areas were fixed with Polycrylic and shear snips. The "wRail + Gate" feature is VERY EXPERIMENTAL and is intended to be removed from the back of dicengard, the gate should be removed, and placed where the dice tumble out to catch them. V2 and the Removable Gate are untested. If you print these pieces, please post a comment or photo so that adjustments can be made if needed. 06/28/18: The "No Rail" setup was printed with a tight fit and tray stays in without issue. 07/01/18: The Original design extruded nearly all of the inner down slope, leaving it weak with only 1-2 layers. 07/07/18: Only pegs were added as my printer did not like printing these with the top piece. 07/08/18: V2 was made where the inner part of dicengard is thicker where the tray goes. Grooves for the V2 wRail+Gate to slide in against the front and lock in were also added. Dicengard is a shorter, chubbier version of Isengard that's also a dice tower! Having a fence or something to catch the dice when they leave the tower is suggested as they tend to come out at a pretty high rate of speed. Also, for the top and bottom half version, the pins are intended more for alignment than strength, you can choose to change the orientation or use something else as pins if you desire more strength at the join.