Dice Tray and Holder

thingiverse

This should be a fairly simple dice tray and holder to print for most printers that are large enough to print it. The outer edges of the dice tray measure 15.4 cm x 21.4 cm x 5 cm. The built-in dice holder should be capable of holding 8 standard-sized dice (d4-d20). The points at both ends of the dice holder are sized appropriately to hold 5 mm x 1 mm magnets to keep the lid in place, with a small allowance for printer tolerance. The sides of the lid were also sized down to provide a decent tolerance, just in case. Please share any prints that you have done and share any comments or improvements that you may have. You are free to use this or build upon this design, future improvements do include a lid for the dice tray. Enjoy! - Sean EDIT (3/8/2018): The magnet receivers for the lid were fixed, one had previously been drawn too deep and they are now at the same depth. EDIT (3/9/2018): The first prototype was finally printed, setting everything so that my printer could print as fast as possible. The base printed without a problem. The lid also printed without a problem, I have uploaded a new .STL with beveled edges on the lid. It was noticed when taking the lid out of the base it could sometimes be difficult with dice in the tray, so this change is hoped to help with that. A new lid is being printed now and will upload pictures for everyone later this afternoon. Thank you. EDIT #2 (3/9/2018): The size of receptors for magnets was increased to make it easier for insertion of magnets. Originally it was a bit of a tight fit, they should fit much easier though. If anyone has any problems I can increase the tolerance in future versions.