Dice Box and Tray - Don't Care Remix

thingiverse

Remix of a remix to add more spots for dice (14). I printed it at 100% at first and found the spots for the dice a bit snug for my DnD Essentials kit dice and Chessex set. I would suggest you print it at 105%. i also printed the top slightly higher than that on the Z axis to give my mini some breathing room. Printed the top at 100% infill as it's going to be the landing zone for the dice from my dice tower. At 105% these 6mm X 3mm TRYMAG magnets from the rainforest https://www.amazon.com/gp/product/B09QHSB2XM/ press fit in quiet nicely. I'm probably going to try to glue them in, but I'm not even sure glue would fit with the magnet. I am by no means an expert in 3ding stuff so there are a lot of weird things going on with this if you look at the mesh but it prints fine. I basically just copy and pasted it together in Blender and didn't care enough to make it pretty. I wanted it and thought maybe someone else would. Cura reports extraneous surfaces (I don't care, it prints fine) I accidentally left the EI lettering from Endlessly_Iterating's remix in (I don't care, it prints fine but I also wish I removed it before printing) The D20 logo thing could probably be a bit deeper or wider (I don't care enough to print it again) One of the center holes is rounded, probably from duplicating the mesh and not realizing that the rounded mini thing is part of the walls of that hole (I don't care, it holds dice fine) I made the print in the picture using Hatchbox wood PLA which apparently has wood content somewhere in the teens, percentage-wise. 0.6mm nozzle, 0.3mm layer height, stained with Minwax Red Mahagony oil-based. Took a surprisingly-long time to dry, even in a heated and ventilated box with good airflow. Probably due to the lack of wood content in the PLA. No poly yet.