Diatone GT-R349 - Le Drone Ramone

thingiverse

I designed mine with a 0.7 layer height, which pairs well with my 0.8 nozzle, and I didn't add any supports since they're unnecessary for this model. To keep things lightweight, I went with 0% infill and walls that are approximately 0.8mm thick. Since my frame isn't hollowed out like the ducts, it remains solid due to the thickness of my top and bottom layers. If you're using a smaller nozzle, such as a 0.4mm one, consider simplifying your print settings in Simplify3D: set your frame to 100% infill and leave the rest of the ducts at 0% infill. Printing the entire frame hollow will compromise its strength. P.S. If you'd like to contribute to my cat's well-being, a $1 donation would go a long way in purchasing some much-needed food.