Diatone ET160 ET25/ET200 VTX mount

thingiverse

This is my third part for the ET160 and works perfectly with the other two. It has antenna guides built right in. You may need to print at 105% to get the antenna guides lined up just right, depending on your shrink amount. This part was designed to be super lightweight and to work well with my other two parts to keep weight to a minimum. The ET160 in the picture is a sub-250g build, including battery. Installation tips: When using the antenna guides, I recommend drilling them out to the desired diameter and possibly drilling or filing the top plate a bit to give the antennas more clearance. I use straws from canned air for my antenna guides, so I drill them out so they fit snugly. Another thing I do is to drill or cut into the antenna guide from the bottom of the printed part to create a 1.5mm cone-shaped space underneath. This gives some wiggle room for the wire in case there's a crash and the 3D printed part gets ripped from the frame. (This has saved my wires on my bigger quad several times.) The other two parts used in this build are the x4rsb tray mounted below and behind the vtx, and the sony fpv camera mount. Both are posted here on thingiverse. Here are the transmitters that fit this part perfectly: http://www.banggood.com/Eachine-ET200R-FPV-5_8G-40CH-200mW-Mini-AV-Transmitter-with-RaceBand-p-1022303.html - or http://www.banggood.com/Eachine-ET25R-FPV-5_8G-40CH-25mW-Mini-Transmitter-With-RaceBand-Race-Band-p-1023853.html