Diatone 2019 R349, R249 & R239 - 45 Degree VAS Minion Antenna Mount (Turtle Mode Friendly)

thingiverse

Here's a VAS Minion Antenna (UFL) Mount for the 2019 Diatone R349, R249 and R239 canopy. So I designed three options for this antenna mount because I read that TPU can block or change the 5.8GHz frequency by the time it gets to your goggles. I read on Facebook that Alex Greve (Creator of VAS Antennas) said that TPU doesn't cause video issues if an antenna is covered, but that's what someone posted so I'm not 100% positive TPU doesn't affect FPV frequencies since I didn't see it posted directly from the expert Alex himself. Ways to print: Print the mount and base in one piece (You will need supports) Print in two pieces: You need to print "Part 1 of 2" the base and only one of the three "Part 2 of 2" top portions that the VAS Minion fits inside. Directions are the same as posted in my original antenna https://www.thingiverse.com/thing:3317546 (You will need supports for Part 2) Here's the breakdown of the TPU coverage on the minion: Full = Covers 80% of the Minion Antenna Half = Covers 40% of the Minion Antenna Min = Covers 20% of the Minion Antenna FYI... If you have a Prusa, I found that if you select the flex filament in PE Slic3r and turn on the recommended settings in this YouTube video below my results turned out really good (Not perfect but close enough for me). One thing he didn't mention that will help with small parts like this one is to go to "Filament Settings" Tab and check the "Enable auto cooling" checkbox Here's a good Video on printing TPU: https://www.youtube.com/watch?v=ACRh51hdBxo If you want to support me and my designs or maybe you can't print TPU, then check out my eBay link as I'm selling these on eBay. Besides, it helps motivate me to create and share more and gives me a little money for my hobbies. http://ebay.us/vYaSxf?cmpnId=5338273189