DeWALT Dual Battery Shelf (New Battery Version)

thingiverse

DeWALT Dual Battery Holder (New Battery Edition) This accessory caters specifically to 20-volt batteries, holding two comfortably within side pockets that prevent them from falling out. The front edge is beveled for effortless placement on a wall mount, printed at the base of your printer.\r\n\r\nAfter Printing, I carefully enlarged the holes with a drill to accommodate the screws. Initially, the holes were 1/8 inch in diameter; however, my printer's tolerance may have been off or that size proved too small. To avoid layer splitting, I used a small drill bit and gradually increased the hole size until it fit perfectly.