DeWalt drill and hammer drill driver holder - slanted

thingiverse

I own a pair of DeWalt drills. One standard brushless drill that you see holders for all over this site and another DeWalt hammer drill. I printed cwienands double holder which was awesome, but the hammer drill is a bit wider and required a larger hole. Thus, I expanded the holder on the right to fit the hammer drill or one of the older DeWalt drills. After completing this, I was a bit concerned of the drill sliding out so I added a slight wedge to prevent this. I didn't want to spend another 10 hours printing a whole other holder, so on mine I just printed the additional wedge. If I get bored and want to spend another $5 on material, maybe I'll print a single piece unit, but the additional wedge seems to work fine. FYI, this wedge will not work on cwienands as again I have expanded the holder to fit the hammer drill. I'll try and find some time to make a wedge for the original as well.