Dewalt 20v Atomic series drill and impact driver extra bit and bubble level attachment

thingiverse

I designed this specifically for the Dewalt Atomic series drill and impact driver. Models DCD708B and DCF809B. I took a picture of the drill, imported it into Fusion360 as a canvas and then sketched the dimensions around that. This allowed me to get an exact fit, to the point where it takes a little effort to get it on but once there it doesn't budge at all. I made it to hold 4 bits, each bit holder has a base at the bottom to keep them from falling out, they also have knotches inside so better hold the bit. I then added a horizontal slot to hold extra long bits on the right side. It also holds a 10mm round bubble level on the back so you can tell if you're drilling straight down or not as well as a left side bubble holder for up to 29mm length bubbles. I just put a dab of glue to hold the bubbles in place. Best of all, it requires no supports to print. I printed using PETG on a Prusa Mk3s but PLA would probably work as well. Feel free to drill through the bottom if you need to hold longer bits.