Devil's Pitchfork

thingiverse

This is part of my daughter's "little devil" costume from this past Halloween. I added a small LED to the tip of each one, ran the wires down through the internal channel, and connected them to a battery that I attached to a 5/8-inch wooden dowel which held up the pitchfork. Print Trident_arm_1 and Trident_arm_2 twice Print Trident_Center twice Print Trident_tip three times Assemble the parts together, attaching them securely onto the top of a 5/8-inch wooden dowel. I used translucent red PLA material at a .15 mm thickness with two layers. Optional: insert a small red LED into each chamber, removing excess support material by drilling if necessary. Route wires down through the interior channels and link them to a battery. I used a nine-volt connected directly to the dowel with bright red duct tape.